View Single Post
Old 10-03-2004, 02:06 PM   #18
Speedie
Tech Master
 
Speedie's Avatar
 
Join Date: Feb 2003
Location: Wisconsin
Posts: 1,844
Default

It should be loose in the arm. The block doesnt matter because it doesnt pivoit in there. What I do is I run the set screw all the way into the hole and take it back out and run a drill bit the size of the pins through it to clean it out. There not loose after that but its easier to work on when it pushes out easier.
__________________
www.victoryhobbies.com Greenbay, Wisconsin
Speedie is offline   Reply With Quote