View Single Post
Old 10-01-2012, 03:14 PM   #899
Cpt.America
Super Moderator
 
Cpt.America's Avatar
R/C Tech Elite Subscriber
 
Join Date: Mar 2009
Location: Washington State
Posts: 11,081
Trader Rating: 52 (100%+)
Default

Quote:
Originally Posted by fastestwon View Post
FYI guys you are definitely going to want the aluminum rear arm mounts the stock plastic ones are fat and limit ur motor adjustments also they seem to pull out during racing so make sure you check them after every run . i found one of my older aluminum arm mounts and put it on. so next time the car will be more consistent during the race . and with the aluminum arm mount i can run the pinon i want to . i am able to go from a 22 tooth to a 31 where as with the plastic i was only able to use the 29 tooth as my smallest .
Are you referring to the suspension hangers? If so, do you know if the ones from the RB5 are a direct swap onto the RB6?
__________________
A big thanks to my sponsors:
- Fantom Racing - www.fantomracing.com -
- Fusion Graphix- www.fusiongraphix.com -
- RCSpecialties -
Cpt.America is offline   Reply With Quote