View Single Post
Old 10-01-2012, 03:08 PM   #898
Cpt.America
Super Moderator
 
Cpt.America's Avatar
R/C Tech Elite Subscriber
 
Join Date: Mar 2009
Location: Washington State
Posts: 11,081
Trader Rating: 52 (100%+)
Default

Quote:
Originally Posted by Brad S. View Post
What size shock ends did you use by chance for the front and rear? When I looked at Tebo's setup, I could not achieve 27mm in between the bottom of the shock and the rod end on the rear. The rod end could not screw on far enough. Any help???

Thanks,

Brad
USUALLY...(i can't say for sure in this instance), tebo measures from the bottom of the bottom shock cap, to the TOP of the rod end. Basically, the overall length of shock shaft that shows when its fully extended. If you combine THAT number, while using the same shock ends... you have your setup. It's all in efforts to achieve a certain amount of droop. If you have a link to the setup sheet you're reading, I'd be happy to look at it to confirm... (its of course possible he measured it a different way.. just going on past tebo setups iv looked at)
__________________
A big thanks to my sponsors:
- Fantom Racing - www.fantomracing.com -
- Fusion Graphix- www.fusiongraphix.com -
- RCSpecialties -
Cpt.America is offline   Reply With Quote