Ok I finally got the thing to idle with a small gap. I just kept lowering the low speed until it would stay running. Idle gap is about the width of a credit card. I tested it on the stand and when I rev it the idle drops back nicely. I will do more testing on the ground tomorrow. I wound up with the needle around 3 3/4 to 3 1/2 turns out from flush on lsn. Factory is 5 turns which is way rich and I think that was causing me to have to run a bigger gap to keep it running and in turn was causing my high idle issue. Hsn around 3 turns. It idles good here I just hope it's not too lean. What kind of settings are people finding as far as lsn on the Roma? Thanks again.