R/C Tech Forums - View Single Post - Mugen MRX4-X clutch question
Thread: Mugen MRX4-X clutch question
View Single Post
Old 09-26-2012, 12:13 PM
  #3  
luvtorun
Tech Regular
iTrader: (18)
 
luvtorun's Avatar
 
Join Date: Jul 2010
Posts: 496
Trader Rating: 18 (100%+)
Default
Originally Posted by JamesHealey
Pre-Load your spring about 1mm down with the screw.

Shim the clutch so there is a gap of 0.7mm.

You measure this with the bearings on the clutch shoe side removed from the bell.

:-)

Check the manual dude also it explains it better than me.
Thank you. You explained it perfectly.
luvtorun is offline  
Reply