R/C Tech Forums - View Single Post - World GT - WGT - 200mm Pan Spec
Thread: World GT - WGT - 200mm Pan Spec
View Single Post
Old 09-24-2012, 01:10 PM
  #176  
RedBullFiXX
Tech Champion
iTrader: (34)
 
RedBullFiXX's Avatar
 
Join Date: Mar 2003
Location: Intergalactic Planetary
Posts: 6,542
Trader Rating: 34 (100%+)
Default
Originally Posted by Green Machine!
Glad I got to meet ya Sunday. Thanks Dave (and everyone else too) for all the answers to my questions. Think I'll be down to practice finally this week. ....one more question then I'm out of everyone's hair. You recomended to start at around 88 rollout Was that correct? With my 88t spur, I couldn't fit a big enough pinion to achieve that. Running 54-53mm tire diameter. I assume if I can get a 84/44 gearing to fit, I should be there. correct? I used Sean's rollout/gear calculator.
88/46 looks correct
It's Odd that your car won't accept that combo
I have run much more gear than that

If that's the case you may need a smaller spur to get the range you are looking for ?
RedBullFiXX is offline  
Reply