Originally posted by rcpanama
I install last night the new servo saver arm with the newer 2 piece diff adjuster for the front Ball Diff and it hits the left bulkhead, so I had to go back installing the original servo saver arm.
I am using the rod linkage in top with the original servo saver; definitely this will not work because it will hit the ball diff (with 2 piece adjuster install), so I did change this but could not solve the problem with the left bulkhead.
Any recommendation how to solve this?
Is it the lever(short one) or the ball end that hit left bulkhead ?
Or the button head from the screw that hit the lower part of left bulkhead?
Check Pyramid link, I did use 5mm baljoint+ball end from my T1FK from servo saver arm to knuckle. But for arm that goes to servo Im still using 6mm one.