Originally Posted by
Bob Barry
what are you guys using for battery foams when you run shorty packs? Does the short course foam work well? 1 in front 1 in the rear? Right now I have just a bunch of foams in there but I would like to make it 1 front 1 rear if possible to avoid me moving one by accident
I took the sc10 battery foam and cut in half and it seems to work pretty good, takes a little bit of force to compress the foam to push the battery in but not too much to worry about cutting more foam off.
Originally Posted by
ilanstylz
Ok heading to the track tomorrow after about a two week break. Last time at the track I was having issue's with the rear end being very loose, after landing jumps and trying to get on the throttle I was always sliding out (the rear)...... What are some things I can do to eliminate this, besides the obvious throttle control, tires etc?
With the softer springs that should be less likely to happen
Originally Posted by
mxracer458
What shock springs And oil and pistons you running,at sdrc I'm running Losi yellow/red combo with #2 pistons,32.5 30wt Losi oils
At sdrc, not sure if i already told you what im running but kyosho white front, 32.5 ae oil, #2 piston, 3 limiters. rear kyosho gold, 30w ae oil #2 piston, 2 limiters. If you need even more steering try the pink kyoshos. Note on the pistons im running ghea tapered pistons with the taper facing upwards. Not sure if its better then stock ae pistons or non tapered gheas but its what i had and it works but i need to compare to stock #2 pistons.
Originally Posted by
spdrac430
what springs is every one using on there big bore setup and their v2's with big bore springs
See above, i run on a indoor med. bite track with a mixture of clay and dirt.