Originally Posted by
fung_kyle
Well I'm trying to remove the head of my engine, but he screws are stuck very hard. Do you think heating the engine up with a heat gun will loosen it up?
Thanks
yes,heat it up,and use a wery big screwdriver.
If i dont remember wrong i did use a 4mm first.I could lurk it around in the screwhead and it did ruin the screws a little.
Then i find a bigger and thicker 5mm that fits just exactly in the screwhead.
I had to hammer it a little to fit.And with the bigger handle of this screwdriver it was a piece of cake to get it loose.