Originally Posted by
NolanP
As i have now done some research with the car.
Kyosho makes a gear that has four holes Kyotf015-94 then just change the last two 88 or 96. Both those should put you in the wheel house for 17.5/13.5
Robinson Makes gears but it will only allow two screws
Kimbrough same concept only two screws.
CRC makes some gears two screws
All 88-96 range.
As I continue to get this going I will post a setup sheet once I finally get to run the car which is looking like next weekend.
I am using an old Yokomo in VTA. I use 12th scale spur gears to get into the 3.5FDR range. Just have to drill the two extra holes myself.