R/C Tech Forums - View Single Post - Bearings for motor?
View Single Post
Old 09-20-2012 | 03:02 PM
  #4  
trickedout's Avatar
trickedout
Tech Master
iTrader: (31)
 
Joined: Jun 2009
Posts: 1,273
From: Las Vegas/Pahrump,NV
Default

Im not a bearing expert but usually there is rubber shielded or metal shielded bearings. I'm not sure about the fiber you speak of but Any bearing the proper size should work just fine. Ceramic is only good for on road in my experience as dirt is not there friend.. Not that it is any bearings friend haha
trickedout is offline