I'm currently using oneway front. Perhaps I'm using the highest roll center in the front. Rear diff is medium hard with 40 shore all around.

Yellow spring in front (on shock tower hole 3) and red spring rear (on shock tower hole 3). 40 wt Serpent shock oil with 4 x 1.2 mm holes. Front sway bar hardest at 90 degree. Rear sway bar (stock 2 mm) is about 12 mm from the end (mounted inner hole on the rear lower arm). Camber is -2 in the front and -4 and -3.5 in the rear left and right respectively. Rear toe in +1.5 and front toe out is -0.75. I think the front droop is either +1 or 0 and rear is somewhere +6 to +8. Caster is 3 mm at the back of the front arm. So using a shorter wheelbase by 2 mm, I use a 1 mm caster at the back of the front arm.