R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 09-17-2012 | 11:50 AM
  #20685  
Eli's Avatar
Eli
Tech Master
iTrader: (15)
 
Joined: Apr 2010
Posts: 1,553
From: San Diego, CA.
Default
Originally Posted by FLHX1550
Question on front hex conversion for the the B4.1

My car is new and I built it with the AE hex conversion knuckles & axles, with JCon hex adapters, and I have one side that when you tighten the wheel there is a decent amount of bind on one side. The other I can tighten very tight and it rolls fine, the other, it drags.

Ive heard of others with the problem, they just run the wheel on one side not as tight. I would rather just fix / solve the problem but really can't find anything that jumps out as the issue.

Wondered if others might be seeing the same thing or have a fix?
are you using the e clips? if so remove the e cliip and re-assemble.
Eli is offline  
Reply