R/C Tech Forums - View Single Post - Houstons Engine Service H.E.S.
View Single Post
Old 09-12-2012 | 06:34 PM
  #7066  
beidle99's Avatar
beidle99
Tech Master
iTrader: (9)
 
Joined: Jan 2005
Posts: 1,932
From: Woodbury, NJ
Default

Originally Posted by savannahmick
I am doing heat cycles on my new X3L HES tuned and it got a bbi from Houston +1 and I tell you this motor runs super smooth no problems with the bbi and 10 tanks I have ran and I already like it! It runs so good I keep wanting to richen it up but it's out from flush at least a full turn on hsn and just a 1/4 turn out from flush lsn also blowing smoke like a diesel at 220f with a sock on it. Paranoid I guess? Anyway I am ready for this weekend! Thanks Monty!
By reading your signature I'm sure you know this but...go easy on her for that first gallon and then ease into the race tune after YOUR first gallon and she will last a loooooong time. I didn't think preheating was that important but I followed Monty's advice and I have always preheated my motor before every start and at at 4 gallons I still have a hard time turning the motor over by hand when its cold. no mechanical pinch just tons of compression.

RC CARS ARE COOL!!!
beidle99 is offline