Originally Posted by
Wild Cherry
Pretty sure I will have to use the Ae rear drive plate with , but otherwise will be using soon .
( AVID 87T spur & Robinson pinion)
Already used a AVID slipper for a few runs with my B4
Will order my AVIDs later this week...
And of course ...
Will tell everyone about how they performed for me after I get ....
The Triad is designed for 10th scale 2wd, 4wd, and SC10. It doesn't fit onto the SC10 4x4 due to the inner drive pulley/hub design. To get it to work you'd have to lathe down the inner pulley drive hub to 18.5mm. We haven't even tested it to be honest.
The 4wd SC and 550 motors requires a different setup than the Triad to be optimized....the VTS4 was designed for the 4x4 and you should run it. We did design the Triad for SC10 and it works great on my truck and makes it feel more planted and less wheel spin!