Originally Posted by
BIGSKI15
Does anyone run 12mm hex in the rear only, to prevent stripping out the slot on the stock wheel? Im going to order wheels tomorrow and thought about buying a hex setup for the rear but buy stock syle wheels for the front.
Any pros/cons to setting it up this way or should I just buy slotted rear wheels?
Im not sure what type of wheel nuts you are using in the rear but when i ran pin style rear wheels the only time i had a problem striping them out was due to a worn out nylock nut. Jconcepts sells serrated wheel nuts that should eliminate that problem if you wish to stick to the pin style wheel. I personally am running hex all around.