Can anyone help out? Back in page 867 post#12998 a picture of an aluminum center diff mount was posted. I've send a pm to rave1010hk but got no reply.Does anyone know where one can buy one? I know most all of you will say it's not needed, but I rebuild my car at least once a month and I'm tired of stripped plastics. Any help on how to resolve my problem or any link to aluminum center diff mounts will be GREATLY!! appreciated.
Diamantis.
I know you want the al center but if you get another plastic one, don't over tighten the top screws. Snug them down only. They don't get a lot of forces acting against them (which is why the al is way over kill) while in use so there is no need for much torque on these. Even a little less than snug is ok. I have stripped these before and ran them stripped till I could get a replacement. I never had a stripped one back out so a slightly snug one won't back out. I am assuming you are talking about the four screws on the top, not the bottom.