Originally Posted by
wrxnut
hay guys this is my first post on rcteck so i will try not to seem bumb but i have a bunch of parts for my tc3 that is a nitro right now but i might make it E depending on how well i get it to drift so what im asking is what do i need to do to make it a CS and how do i lock the back axle and were can i find front one ways for it....
question #2 i have a zero s roller for my brother what gears do i need to set it up with CS like a 75% or 130% thanks guys a bunch
Good luck with that TC3, you might be able to ghetto rig Yokomo CS gears to it, but for the most part if there isn't an aftermarket option available for your car you'll need to find a way to fit gears to it. That's one of the problems of shaft. There's a FOW available for the NTC3.
As far as CS'ing your
Sakura Zero, check out that website. They'll be able to help you more than this forum can. Alot easier for belt CS!
Copied this from CS Junkies:
Gearing:
FDR: F: 8.33 R: 4.85
Front: 40T
Center: 16/22T
Rear: 32T
Spur: 80T
Pinion: 24T