R/C Tech Forums - View Single Post - SC10 Thread Part 2
Thread: SC10 Thread Part 2
View Single Post
Old 08-27-2012 | 04:04 PM
  #878  
trixter91's Avatar
trixter91
Tech Master
iTrader: (4)
 
Joined: Jan 2005
Posts: 1,930
From: Tom Cruises stunt double.
Default
Originally Posted by J_Bone
You can still set the slipper on the SC10 so it lifts off the front tires an inch or more. I have the Factory team torque pads set for one inch and have no issues. If yours can't achieve this, you may have glazed pads or the RS (white) ones?


More timing will give you more top ens and less torque. So you can try even going a gear or so lower and get more top end.
I run my ballistic at stock 30 degrees timing with 20/84.
How do you set the factory team pads for 1 inch? And if they are glazed over what grit sand paper do u scruff them up with?
trixter91 is offline  
Reply