R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 08-25-2012 | 10:32 PM
  #19337  
Wild Cherry's Avatar
Wild Cherry
Tech Legend
 
Joined: Aug 2001
Posts: 22,595
From: TRCR Modified Driver
Default
Originally Posted by RC_nooberton
I"m having trouble bolting down the 2 bottom screws of my servo. It seems the hex driver can't quite 'reach around the corner' well enough to get a straight on angle. I can get them in part way, but they are on an angle.

Anyone else have this issue and how did you overcome it?
Remove the two screws holding the servo to chassis, remove servo then tighten down bottom screws ..
Wild Cherry is offline  
Reply