Just wondering if.....
anyone has any ideas for receiver mounting.
I have a JrXs3 receiver for my CGM and I have a Nosram esc both of which will fit the area where the radio gear is supposed to go (admittedly with the receiver on it's side) BUT......
to be able to access the pots for adjusting the frequency, even with this small esc, I'll still have to mount the receiver in such a way that I can lift it out to change the frequency as the esc is just big enough to block the adjusters.
I could put it on the servo but I'd rather not and velcro just isn't up to the job and double sided tape would just be a pain replacing every time.
So just wondering if anyone has alternate methods of fixing their receivers in the tray?