R/C Tech Forums - View Single Post - Shortening Hitec servo wires...?
Thread: Shortening Hitec servo wires...?
View Single Post
Old 08-22-2012, 09:21 PM
  #10  
8T
Tech Adept
 
8T's Avatar
 
Join Date: Feb 2008
Location: Valley Village, Ca
Posts: 167
Default
The traces on the circuit board are really thin and it doesn't take much heat to start lifting them off the board. If you have some smt experence, no worries. If not, use the tool or pliers(carefully) and cut to length and replace the connectors!
8T is offline  
Reply