R/C Tech Forums - View Single Post - limiting micro servo voltage
Thread: limiting micro servo voltage
View Single Post
Old 08-22-2012 | 02:28 AM
  #2  
TOM MAR's Avatar
TOM MAR
Tech Master
iTrader: (3)
 
Joined: Nov 2009
Posts: 1,061
From: Jacksonville, Florida
Default
Use rectifier diodes, each one drops the voltage.3 or .4 volts at all times & will only work in one direction. A resistor will only drop the voltage while under a load putting the full voltage on your servo anytime it is at rest.
TOM MAR is offline  
Reply