hi.. all novarossi loverss..

i have some questions from you guys since i'm new to RC and a little confuse about tuning breaking in and many more .

so these are my questions :

1. Choosing the right glow plug. I'm from tropical wheather its about 30 - 37 Celcius. and i see from the novarossi that i should use c7tgc for my engine but some says i should use c5tgc i'm a bit confuse. so i finally decide to use c6tgc wich in the mid. but i'm curious if i go to c5 or c7 how that will effect the performence of my motor.

2. from my experience the novarossi glowplug is harder to heat is it true?? my friends says only use a full charge glow heater to heat novarossi glowplug. half full wont go. any tips for that

3. the copper shim. i'm total noob for this thing and googling around not helping at all. how to make a good tune for this part .

4. in my case (4btt) my standard LSN is wayy sunk is it fine? it's may be only one turn from full turn. my engine quite new but it's already that lean for LSN any clue??

5. from the manual of my kit (mbx6r) i should go for 0.5 to 1 mm for the idle but from what i learn and watch idle will be vary to suit your HSN and LSN. i don't get this one. since i flip my car frequently i go for 1mm so the car won't go out since there only few marshal in my track. how to adjust the idle any clue??

6. venturi restrictor. when i go for big venturi when i go for small one. my carb is a new carb any helpp..

7. foam filter. i use a motocros oil for foam filter wich is very2 cheap compare to rc specific oil. is it fine? i use grease too for the side and the screw to seal my filter so finally no air from side. is it fine to do that.

8. my track is tight and have jumps that needed full torque to get pass the last jump any clue for the gearing i'm helpless with the gearing system i use 13/44 standard for my car (sorry out of engine topic).

9. breakin procedure. frankly speaking i never breaking in my engine my self but i'm willing to try it. how to get a good breakin for my motor 4btt tune. i know there are lot's of methods out there but i'm not sure wich one to choose. and i don't have that engine heater so is it ok for me to go. i'm thinking to use the afterrun oil so the slip and the piston will slip a little and loosen the glow plug a bit. after that i have no clue still wandering though i have another 4btt that haven't got breakin. that wil be my testing engine for breaking in my self.

10. the pipe and manifolds. i'm using mugen car. from what i know the manifold for mugen diffrent from others. my track is tight so wich pipe and manifold to choose. it will be a big help if you can explain why choosing it instead of the others.


so that's all my questions guyss helpp will be appreciated for i'm a noob in RC. and i love to learn. waww it's 10 questions for you guys i hope you'll love it.