R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 08-17-2012 | 08:30 AM
  #18845  
Waflet's Avatar
Waflet
Tech Master
iTrader: (35)
 
Joined: Oct 2011
Posts: 1,926
From: helena, alabama
Default

Originally Posted by Matt Trimmings
yeah, dont you mount the ball stud on the u brace upside down with 5 washers?
Hideeho
I know this was entered as a joke, but how low could the link be & still give good returns? I understand that lowering the roll center on one end substantialy more than on the other end is a bad. I have heard that for on road you want the roll center as low as possible (below ground level is not uncommon). What would be the drawbacks of a similar setup for offroad (assumeing front & rear are balanced)?
Waflet is offline