servo failure
i just had a ace xp1313 servo fail on me last night. i installed a new m11x recevier in my sc10 last night. all was well right after i did the bind process. steering was working great. but after i started adjusting the end points. i noticed the servo started acting wierd. would run very slow in some directions and sometimes not respond at all. i dont think the radio or settings are causing it. i did try another servo and it worked fine. im new to electric cars with lipos. since the lipo is at 8.4 volts fully charged. does the servo see 8.4 volts? if so do i need a high voltage servo or a voltage regulator?