Originally Posted by
Joe B
Also, another option (when running aluminum servo horns) is to get rid of all the plastic shims underneath the servo anchor screws altogether (further reducing servo flex), and run your plastic arm to the "outside" of your aluminum servo horn (instead of inside)..... this setup (with most servos) will allow the arm to be aligned nice and straight... And not contact anything at all........ Joe
Has I have just swapped out servo's for Orion Vds, had a Futaba in, just going Hv,and waiting on my HB servo horn will be removing the spacers,has the vds doesn't sit right with the spacers,and the Fullforce clamps don't clamp had good either,mmm
So will be on the other side