R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 08-09-2012 | 11:10 AM
  #18249  
bds81175's Avatar
bds81175
Moderator
iTrader: (20)
 
Joined: Jan 2011
Posts: 2,745
From: Litchfield, Minnesota
Default
Originally Posted by PFKAOG
Problem is if you currently use the c hub you'll need access to a mill to use these hubs to get the ball stud in the right location
Why is that? You think the top flange surface is higher than the holes on the C hub? That would suck. If its lower, you would just shim up to the level of either the A/B or C hubs.
bds81175 is offline  
Reply