R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 08-09-2012 | 11:07 AM
  #18245  
Wildcat1971's Avatar
Wildcat1971
Tech Prophet
iTrader: (84)
 
Joined: Apr 2012
Posts: 17,389
From: Arizona
Default
Originally Posted by bds81175
Anyone tried these yet?

http://www.amainhobbies.com/product_...ar-Hub-Carrier

They're already tapped for locking onto the hinge pin, use the larger outer bearing and have three different vertical mounting locations for the ball stud. Infinite adjust-ability in hub carrier ball end height. And they are cheaper than the AE units. The question is the fit of the bearings. I agree, if I'm paying $30 for hub carriers I don't want to have to shoe-goo my bearings in and drill and tap holes. I like to tinker but I'd rather have to tinker with the $3.89 plastic GT2 hubs than the $30 aluminum ones.
they dont make a zero degree version. only reason I didnt order some. I was also unsure it was the same as the C hub with no hub washers.
Wildcat1971 is offline  
Reply