R/C Tech Forums - View Single Post - RC10B4.1 FT/WC
Thread: RC10B4.1 FT/WC
View Single Post
Old 08-09-2012 | 11:02 AM
  #18244  
PFKAOG
Suspended
iTrader: (12)
 
Joined: Aug 2010
Posts: 1,990
Default
Originally Posted by bds81175
Anyone tried these yet?

http://www.amainhobbies.com/product_...ar-Hub-Carrier

They're already tapped for locking onto the hinge pin, use the larger outer bearing and have three different vertical mounting locations for the ball stud. Infinite adjust-ability in hub carrier ball end height. And they are cheaper than the AE units. The question is the fit of the bearings. I agree, if I'm paying $30 for hub carriers I don't want to have to shoe-goo my bearings in and drill and tap holes. I like to tinker but I'd rather have to tinker with the $3.89 plastic GT2 hubs than the $30 aluminum ones.
Problem is if you currently use the c hub you'll need access to a mill to use these hubs to get the ball stud in the right location
PFKAOG is offline  
Reply