Ok so I'm trying to find a good boost profile setup for my VST13.5T in a Losi XXX-SCT. I have an email from Eric at Viper with what he uses but I'm not using proguage or a Viper ESC so a bit of translation is needed and I want to make sure I have this right.

I'm thinking a boost starting point of around 3500 rpm with a slope of 550 rpm/deg and a max boost timing advance of 25 deg. So the motor comes from the factory with the can timing set at 30 deg. but I've seen people say to turn that back when running boost. Is there soem sort of general rule to that effect? Or should I just leave it stock?