Hi guys,

I do have a new question for experts:
I used to run on Team Orion motors, and I always left the timing at 0° on the motor with my 2.1.. I bought a V3 and also a new LRP X20 (also at 10.5), just for testing. I was very surprised to see that the motor came with a default timing of 27.5°. I try to put same settings in the V3 I had in the V2.1 and there, bad surprise, thermal cut-off after 120 sec. !

I decided to ask some questions around me about these 27.5° and I got an information about the fact that all sensored brushless motors come with 30° of timing, due to the position of the sensor, and that most of brands just base their scale on this point...

Have you already heard of that?

Since that, I've put directly 30° timing in my X20 and it seems to work better than with 27.5... My opinion is that I have set the timing to "standard 0" when i put 30° timing on the LRP...

I'm quite confused about that, could somebody help me?

Thanks...