Hi guys you may gave read my other threads on this subject but I'm just recaping it all because I'm completely stuck. I have a savage flux when I turn it on I get movement in the servo but no throttle, I figured it just needed to be reprogrammed so I went online and found the instructions, the first step said to hold full throttle then flip on the ESC to begin programming mode. When I tried this nothing changed no lights or sounds just a quick flashing yellow and green LED like always, so I then went online to see what the LEDs meant, it said that yellow and green flashing meant low voltage cutoff. To test this theory I charged my batteries fully then hooked them up but still got nothing. Is there many reasons for a lowvoltage cutoff? Besides the batteries not being charged. The ESC on the savage flux is called the Blur ESC which many say is just the Mamba Max in a different color so I just used all the info from the mamba max to try it on my Blur, so all the instructions and stuff I read were for the mamba max, could it be the 2 ESCs aren't the same after all?

If you guys could help me that would be great, any additional info can be gathered if needed or you could look at my other threads, thanks again for reading.