View Single Post
Old 07-29-2012, 05:29 PM   #382
sir miles
Tech Master
 
sir miles's Avatar
 
Join Date: Jun 2007
Posts: 1,476
Trader Rating: 23 (100%+)
Default

Hi HeliYogi,

With this set up, the biggest pinion I can fit is 19T which is ideal for me using the stock spur that gives me a 3.68 close to 3.71 that our club requires. If you want to experiment about the spur/pinion, try the smaller spur 63t (Tamiya #50506) it also comes with a spare plastic diff which you can also use.

To tell you honestly, it took me sometime to figure out what I can use if I wear out my orig foams. Clever tamiya design, its not far from F103 in some ways. I use the Tamiya F103 rubber tire type B directly like you do a F103 tire mounting. You just have to take out the hex part that attaches to your stock rear wheel. And you put the thrust bearing and washers inside the F103 rim, the mesh design of the rim which is detachable will hold them in place.

BTW, have you noticed the 2 sliders that attaches to the side of my rear suspension?

I'm from Manila Philippines. Im racing this baby against a bunch of multi branded F1.

AYT!
Attached Thumbnails
Click image for larger version

Name:	IMG_3015.JPG
Views:	557
Size:	85.6 KB
ID:	952323   Click image for larger version

Name:	IMG_3013.JPG
Views:	319
Size:	73.3 KB
ID:	952324  
__________________
gaining momentum!

Last edited by sir miles; 07-29-2012 at 05:43 PM.
sir miles is offline   Reply With Quote