+1 Matts truck was dialed in pretty good last night, mine sucked!!
A couple of things to note:
Matt Dean and I all noticed that the truck was missing off power turn in, this is due to the fact that there is barely any front or rear droop. I turn my shock eyelets out 5 turns and it turned on a freaking Dime, Matt turned his eyelets out 3 turns and it was more than enough BUT he also split an outdrive in the front so make sure you use at least 6mm of limiters on the shock shaft above the eyelets.
Also the Losi and Kyosho pistons will fit but they are just slightly smaller (.005") this is not a big deal and probably the reason Matt can run 4 hole pistons with relatively thick oil. with that being said his suspension was on point! The pistons i had in my truck were 5 hole and i was running 250wt (about 22wt losi ) and my truck was super stiff due to the fact that i had the ID to piston clearance of only .003" which is too tight. i will address that today and test the truck again tomorrow.