Got to down load the vlink today works pretty good other then after making changes it wouldn't allow you to keep profile #2 to the esc it would revert back to profile 1, the changes i made in profile 2 were done just couldn't save that profile number to esc, i had to use the pro gauge to set it to profile 2 and check if the changes were there i made and they were, i then went back into the vlink to see if i could change to another profile and couldn't change out of now profile 2 that i used the pro gauge to set to, soooo is this a glitch or are we not able to switch between profiles using the vlink and have to use the pro gauge for that.

oppps i see not that silvalis ask that same question sorry, can that be fixed so we can save profiles. Thanks