R/C Tech Forums - View Single Post - Go-Tech Engines Thread
Thread: Go-Tech Engines Thread
View Single Post
Old 07-13-2012 | 11:02 AM
  #14293  
motomatt's Avatar
motomatt
Tech Master
iTrader: (12)
 
Joined: Mar 2007
Posts: 1,283
From: WI
Default
Originally Posted by HyperB5
Will the Novarossi NVR17011 front engine bearing fit the GXII-5RHO?
The GXII-5RHO front bearing size is 7x19x6.
The 17011 Nova bearing is 7x19x6.3.

If I'm correct, the extra width of the Nova bearing is because it has double seals at the front side. It would fit in the GO, but the extra width would cause it to protrude very slightly. This would then cause the clutch bell to be 0.3mm (about 0.013-0.014") farther forward than previously. I'm sure alternate shimming of the flywheel and clutch could compensate for this.
motomatt is offline  
Reply