Im not racing nitro anymore so its time to sell my buggy.
Agama A8 Evo buggy with a ton of parts, some used some new. Most of the new parts came from a second kit, so they are in kit bags.
This buggy has around 4 gallons of track time on it. Parts that needed to be replaced were with new parts like all CVAs, stub axles, arms, and hinge pins. Includes JP-3 pipe
The roller has a hitec steering horn, and futaba throttle horn both are aluminium.Also has 10* aluminium castor blocks
The engine in the buggy is a v-spec that has two tanks of fuel through it so it still needs breakin. It also has a ninja jx crank that was use in the other engine for around two gallons.
The second engine has around 4 gallons through it. It runs fine the only problem is the BLOCK IS CRACKED under a mounting tab. It has a new stock crank in it.
Parts in boxes are....
F&R gear boxes
F&R hinge pin holders
couple hinge pins
F&R skid plates
9 assorted F&R swaybars
New built underdriven rear diff
3x brake rotors
Pair of rear hubs
Pair of front castor blocks
Par of front steering knuckles
asorted kit screws
assorted bearings...new
hinge pin holder inserts...new and used
4x wheel hexes and nuts
2x compleat shock rebuilds
Assorted tapered shock pistons
2x sets of kit grey springs....used
2x front shock bodies
3x rear shock bodies
pair of rear yellow long springs
pair of orange front springs
3x rear shock shafts
1 front shock shaft
4x shock caps...new
assorted used cvas
used TI stub axles
2x engine mounts
tons of clutch shoes and springs
3 clutch bells..
Nip kit parts are....
built center diff in mount
White wing
chassis
engine brace
Mud guards
Wing mount
Fuel tank
Brake parts
Odonell clutch springs
Vp-Pro exhaust gaskets
Throttle and brake linkages
Agama exhaust gaskets
Steering rack
Link balls
Front chassis brace
Turn buckles and rod ends
Im shure there is something I missed, if you have questions PM me.
Looking for $300 O.B.O. shipped in the U.S. Paypal only....I need this gone!
