Originally Posted by SMR 510RR

Finally got to run the truck today with the 8mm mod done. It is way better, still needs a little tweaking for outdoor but on indoor it was basically dialed in. Its nice to have multiple tracks in one place to test out different ideas.

The last problem I am having is that the rear end wants to come around at high speed typically on the brakes.

Setup:
Front blue springs-rear red springs FRONT GREEN/WHITE IN REAR/ YELLOWS IN THE FRONT
Blue Swaybars front and rear YELLOW IN FRONT
35w front 30w rear
All shocks middle hole top outside bottom INSIDE ON THE REAR ARM
8mm mod
24mm ride heightLOWER REAR TO 23MM
v2 cdif 4 pins
.5oz weight in the front of chassis (added this afternoon, drives about the same with and without the weight)

Its not bad, it just wants to rotate too much on corner entry on the higher speed sweepers...If I push too hard into the corner I am going for a ride. The 8mm mod did make a huge difference but I just need a little more. I dont really want to swap springs as I like how the truck jumps and lands, if anything I would go up a spring front and rear to yellow fronts with green fronts in the rear.

I am thinking that maybe a slightly stiffer bar in the front may be my next tweak, seemed like the front had a little bit too much roll and that would make the rear softer in relation to the front. Curious to see what you guys would suggest.