Originally Posted by
LadiesFirst
Thanks, Trickedout. It didn't work. I went in and changed it to C2 and when I tried to apply the settings, it gave me the menu that said do you want to save the settings to the speed control? I clicked ok. And instead of saying the settings have been saved to the speed control, it just said "settings saved". I tried it three times. Don't know what's going on. I did earlier click on update, so maybe that messed it up.
I'm not gonna bother with it anymore, I'll just run it this way and just use this ESC for play instead of racing. I don't have a lot of time to mess with it, and when I downloaded the original software, there were problems getting it to load onto my computer. Randy Pike helped me load it and he even had trouble with it, so I don't have the time to reload the software it that's what it needs right now. I thank you for your great help though because I had forgotten where it was on the menu - layered under Setup, then Throttle. I was not going deep enough. Like I said, I've only used it once or twice so wasn't very familiar with it. Once I get more time, I will get more familiar and hopefully do more with it, but I don't have a laptop, so once I'm at the track, I'm stuck.
Thanks again.
No prob. What exactly "didn't work"? Ive had issues sometimes getting the software to work correctly with the esc on my laptop..It can be very touchy sometimes as you have figured out. If you are just wanting to run Blinky stock mode but adjust some of the other settings like forward/brake/rev modes and brake control and stuff it should save and those general settings will save for EVERY throttle profile...Example you can have say profile 1(Blinky) be just Forward/Brake and no reverse and say 50% brake power...and then have profile 2 running forward with brake and reverse and 100% brake power...THAT will NOT work, those settings are saved over every profile including the C1,C2 custom profiles..
If you are just wanting to run Blinky mode and have troubles selecting it with the Hotwire, theres still the buttons and LED lights on the esc to select things such as profiles. I beleive once you have the esc on, if you tap the Left button i beleive its "mode" tap it 5 times until you see 5 LED lights and it will be at TP. hit the right button which is selet. then tap it until only the first LED on the left is light and that is profile 1 which is stock. then just wait a few seconds lights will blink and then it will switch to blinky mode where 2 middle lights will stay blinking while at neutral. Hope all this helps and if you knew all that then sorry for the old story. HaHa