Originally Posted by ilanstylz

Most people on here from what I've read run 24mm ride height, I am down to 23mm because of the new layout at my local track......

Originally Posted by BorackBasher

yup.. i even went down to 23 all around.. i asked this guy steven hartsen.. ae driver and he said 27 all around he's pretty dialed guy so i listen to him.. but when i drove the car it seemed like it was dancing all over the place.. so i went back to 24 all around it was fixed.. i think his set up was a bit different from mine.. preference maybe..

Originally Posted by Krio

Keep in mind the ride height is measured at the center chassis in front of the rear wheel and behind the front wheel. If you measure 23 mm at the very back below the rear diff the center section of the chassis will be way too low.

Originally Posted by Wild Cherry

Tips on setting ride height



*measure from ft & back center chassis

*24mm is standard height or med

*Higher traction =lower ride height

*Less traction = higher ride height

rear height
22.5mm max low
25 mm high


ft height
23 low
25 high