Just now have about 2 gallons on my CRE P5 and I am loving it. I am taking it out of the buggy this week to drop in a ceramic rear bearing and a nova double seal front bearing and just generally go through the motor before the big races coming up.

Couple of questions for you guys. Are you setting the .6mm idle gap with the venturi in the car or out of the carb? I imagine it is out of the carb just like my Werks motors, but I just want to make sure. Also, are the stock needle settings the 3.5 turns out from flush (high) and flush w/ housing (low) like it says on Nova's site?

Thanks again for a killer motor!