I just went to put on the Saddle pack conversion & stripped
2 of the 3x10mm FHS, putting on the L/R cradles???
The screws were going in nice & easy from the bottom of the chassis,
then half way thru they started get really hard to turn. I pulled them out
and tried again & when I got half way thru, they were impossible to turn,
and finally the heads got stripped. It is the same with both Left & Right cradles..

What is going on, was I suppose to thread the screw holes??
I'm using the Exotek chassis, but that had nothing to do with it...
Now I have to get the screws out, with a dremel and
get more 3x10mm FHS, great!??

by the way, I'm using the AE saddle conv....
help if you have an idea what went wrong?