R/C Tech Forums - View Single Post - Picco 2011 TORQUE onroad engines
Thread: Picco 2011 TORQUE onroad engines
View Single Post
Old 06-24-2012 | 03:24 PM
  #403  
GMartinez's Avatar
GMartinez
Tech Champion
iTrader: (91)
 
Joined: Dec 2004
Posts: 8,480
From: Sunshine State
Default
Originally Posted by chovden
So I have a issue with a 2012 EDO .21, I have broke it in and want to take it apart to check that the piston\sleeve and bearings are OK but I cant get the sleeve out, it moves out maybe .5mm then stops, tried heating it to 200C but wont move any further it moves very frealy sideways when it is at the botom and up approx ,5mm but then it is fully stopped, if I try and get it open by putting some zip ties in the exhaust I just cut them.
Any tips?
Or have anyone expiriensed the same?
I Had the same issue you just have to heat it up more until it loosens
GMartinez is offline  
Reply