i was wondering do you guy have a link for those avid spring you are using for front and rear? Second question is do you guy build like the manual say with the dead shock ? and third what is up with the lower spring retainer it like my springs can fall off to one side they dont hold in place good at all or not like im used to for 1/8 scale truggy any way. i built this for the wife and she was happy i spent all day getting it done while she was out. i just have to change the stuff i dont think is right. i did not have a problem with the steeing bell crank that people said they had to cut for. so iguess i lucked out there. i did have a bad futaba horn which sucks do the make an aluminum servo horn for this or not? I could use a link for that also the plastic one dont seem to fit the savox to good so i dont trust it will hold. thanks rob.