Originally Posted by
alvinsmith75
Unfortunately I have heard several answers to the following questions. They are not consistent. Could someone please help us find the correct answers.
1.What shims should be in the motor during break in?
2.What shims should be in the motor after break in is complete?
It would be nice if this info was included with the motor.
The shim that comes in box with motor can be used for break in
I did not use it for breaking in mine just make sure you get motor up to temp before attempting to start for first time or first gallon or so u will also notice that motor stays really tight for around 2 gallons once loosens up all the way run times get better
good luck with it.