Originally Posted by
tperazzo
Thanks J Bone for sharing your setup. I see you run 2 deg anti-squat.
How do you get 2 deg? Or are you using a 2 deg shim plus the stock block for a total of 4? This has always been a source of confusion for me when looking at the setup sheets on rc10.com too.
My truck has a block that is labeled 3.5 and I'm using no shims. If I want to try 2 deg anti-squat what would I do?
Thanks,
Tom
The 2° antisquat is the shim that goes under your 3.5 toe block. The kits usually comes with a 1° and 2° anti squat shim. Mine has the number stamped in it.
So you would install the shim that's labeled with a number 2 ( some have two dots indented in them) under the toe block. That will give you the 2° anti squat.