Originally Posted by
MrRolla
Ive checked the parts cross reference table, but just want to confirm that T2 arms, uprights, C-Hubs can be used on the T311.
Yes. There might be some variation in hard and extra hard spec arms, also, I think the T2009 might have had the 2 hole arms. T2008 also had the same molding arms and hubs, the T2007 had slightly different arms but the hubs are the same.
Originally Posted by
MrRolla
Also with regards to the L and H blocks are you able to use these in all 4 roll centre positions ( can they be flipped over ) or do you need to use the orange roll centre mounts from the T2009?
Not so sure about this, the orange will fit in all four but I think you need to swap the the blocks between sides rather than turn them upside down.