Originally Posted by
SOuthernFRIED
They have been working out fine for me. I can't swear to the exact height above stock they are, but 3 races on them so far and all is well.
Just curious, but what have you heard bad about them?
I run them.
The bad.
The bearings are machined too close together so the axle moves back and forth some. Easy fix - a 10mm shim in the bearing hole before the bearing goes in.
The stock black spacers are too big around and hit the hub. You can over tighten the pin and bind the hub in the arm. Easy fix - use smaller diameter spacers.
Other than that I like them. My custom camber location tabs are endless with this set-up.