Originally Posted by
Murray100
Small bearing in trans case will not pry out. No access to punch out from the outside of the case. Anyone know a way to get out without damaging the bearing.
I have a pick/hook set that I used. I was able to get the point between the bearing and case and pry it out.
Originally Posted by
ksarantakos
What do you mean by cut down? Are there pics someplace that show this mod?
-kyri
I don't have pics at this moment. On the rear camber link, you grind down flat where the inner ball stud mounts. The stock brace sits up .060/2mm or two washers high.